Argo AES Series Manual de instrucciones descargar pdf (Pagina 89)

-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Gas system

7.3 Changing gas bottles

 Open external gas bottle compartment (see chapter 6).

 Close the regulator tap (Fig. 106,1) on the gas bottle (Fig. 106,2). Pay

attention to the direction of the arrow.

 Unscrew the gas tube (Fig. 106,3) by hand from the gas bottle.

 Release the fixing belts and remove the gas bottle.

 Place a filled gas bottle in the gas bottle compartment.

 Fix gas bottle in place with the fixing belts.

 Screw gas tube on gas bottle by hand.

X Use the shortest possible tube lengths (150 cm max.) for external gas

bottles.

X Never block the floor ventilation openings below the gas bottles.

Z With some models, the gas bottle compartment is located right next to the

conversion door. With these models, only open the gas bottle compartment

when the conversion door is closed. Danger from damages.

Z For gas-operated units the gas pressure must be reduced to 30 mbar.

Z Connect gas pressure regulator complete with safety valve directly to bottle

valve.

The gas pressure regulator reduces the gas pressure in the gas bottle

down to the operating pressure of the gas devices.

Z For filling and connecting the gas bottles in Europe the accessories shops

have corresponding Euro filling sets and Euro bottle sets.

Z Information available at the dealers or service centre.

Z For information on the gas supply in Europe see chapter 17.

X When changing gas bottles, do not smoke or create any open fire.

X When you have changed the gas bottle, check whether gas escapes at

the connection points and unions. Use a leakage search spray to spray

the relevant connection point or union. These agents are available at the

accessories shop.

Fig. 106 Gas bottle compartment

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 261 262

Sin comentarios

Argo AES Series Manual de instrucciones Pagina 89