Argo AES Series Manual de instrucciones Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 262
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
36 A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
During the journey
4
4.2 Parking distance control Park Boy V (special
equipment)
Short description The parking distance control serves as an aid for parking. The distance to pos-
sible obstacles is measured using the ultrasound echo sounder method. Four
sensors at the rear of vehicle send ultrasound signals and the distance to the
obstacle is measured according to the time taken by the reflected ultrasound
signals.
In the passenger compartment, a display unit (Fig. 18) shows the distance to
the obstacle. At the same time, an acute signal sounds as a warning.
The sensors and display unit are linked by radio.
X Be particularly careful when driving backwards. Risk of accident and
injury.
X The parking distance control is only an auxiliary appliance and may not
necessarily recognise all obstacles. The driver of the vehicle is respon-
sible for safety. If the device fails or there is a malfunction and damage
occurs, then claims cannot be asserted against the vehicle manufac-
turer.
X Soil deposits, ice, snow and exhaust fumes can prevent the parking dis-
tance control from working properly.
X Only if you drive slowly (at inching speed) will a warning be emitted in
time.
X Obstacles above or below the sensor measurement area will be ignored
(e.g. projecting load ramps).
X Precipitous embankments or road edges (e.g. quay walls) are ignored.
Z Reflections from the road (a change of surface, irregularities) can some-
times trigger false alarms. This is not due to an error in the parking distance
control.
Fig. 18 Park Boy V display unit
1STOP symbol
2 Distance display in cm (in 5 cm inter-
vals)
3 Distance to the obstacle (graphical
display)
4 On/Off button for the sensors at the
rear of the vehicle
5 Without function
Z When you switch on the ignition, the parking distance control runs a self-
test. If a sensor is defective, this is indicated on the display by rapid
flashing of the sensor position. The parking distance control continues to
function, with the exception of the defective sensor.
If the radio connection is faulty, this will be indicated on the display by
means of a transmission mast symbol. Distance measurement is then not
possible.
When reverse gear is disengaged, the transmission mast symbol is also
briefly displayed.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 261 262

Comentarios a estos manuales

Sin comentarios