Argo AES Series Manual de instrucciones Pagina 217

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 262
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 216
217
A
-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Wheels and tyres
13
Removing the spare wheel: Loosen the nuts (Fig. 239,1) on the right and left rear hooks (Fig. 239,2) of
the spare wheel support.
Unscrew the wheel nuts approx. 3 to 4 cm.
Pull the bar (Fig. 239,3) slightly upwards. At the same time, pull down the
hooks and unhook the bar.
Take down the basket and remove the spare wheel.
13.7 Spare wheel support (special equipment)
The spare wheel support is built into the rear garage.
Removing the spare wheel:
Open external flap of the rear garage.
Loosen and remove both fixing screws (Fig. 240,2) with the on-board tool
set.
Remove the spare wheel (Fig. 240,1) from the support (Fig. 240,3).
13.8 Tyre pressure
Fig. 239 Spare wheel support (basket)
Fig. 240 Spare wheel support in the rear
garage
X Tyres overheat if the tyre pressure is too low. This can cause serious
tyre damage.
X Check tyre pressure before a journey or every 2 weeks. Wrong tyre
pressure causes excessive wear and can lead to damage or even to tyre
burst. You can lose control of the vehicle.
X Use only valves that are approved for the specified tyre pressure.
Vista de pagina 216
1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 261 262

Comentarios a estos manuales

Sin comentarios