Argo AES Series Manual de instrucciones descargar pdf (Pagina 216)

216 A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN

Wheels and tyres

 Park the vehicle on as even and stable a surface as possible.

 Switch off the engine and safeguard the area.

 Go into first gear. In the case of automatic transmission, change gear to "P"

position.

 Apply the handbrake.

 Place wheel chocks or other appropriate objects beneath the opposite

wheel of the vehicle to secure it (Fig. 238).

 Remove the spare wheel from the spare wheel support.

 If the ground is soft, place a stable support such as a wooden board

beneath the vehicle jack.

 Apply the vehicle jack to the designated mounting points (refer to the

instruction manual for the base vehicle).

 Turn the wheel bolts several times to loosen them, but do not remove them.

 Lift the vehicle until the wheel has been lifted 2 to 3 cm above the ground.

 Remove the wheel bolts and take off the wheel.

 Place the spare wheel on the wheel hub and adjust.

 Screw in the wheel bolts and slightly tighten them cross-wise.

 Crank down the vehicle jack and remove it.

 Using the wheelbrace, tighten the wheel bolts evenly (see section 13.5.2

for tightening torque).

 Have the tightening torque checked by an authorised specialist workshop.

13.6 Spare wheel support under the vehicle (special

equipment)

Fig. 238 Securing vehicle

X Due to its weight and fitted position, the spare wheel can be raised or

lowered by a very strong person only. Always get a second person to

assist.

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 261 262

Sin comentarios

Argo AES Series Manual de instrucciones Pagina 216